SAN switches are the core components in your Storage Area Network. Therefore it’s important to monitor the devices correctly to ensure the operational continuity of your storage infrastructure.
The first approach is by implementing Brocade Network Advisor (BNA). BNA is a tool used to manage, monitor and report (performance -, throughput visualization and many more) on fiber channel SAN switches and comes with a cost (platform hosting the software + software licenses/support). Brocade Network Advisor can be integrated with Microsoft System Center Operations Manager with a Management Pack (plugin).
A different approach is by monitoring the devices with plain SNMP traps. This blogpost will guide you through the configuration process of SNMP on Brocade SAN switches. We will be using Microsoft System Center Orchestrator to collect the information in the SNMP traps and push it into a incident management tool. The use of Microsoft System Center is not mandatory, a Nagios could do the trick as well. Continue reading
So recently I encountered a very weird phenomenon at one of my customers and we had a very hard time to determine the root cause of the issue.
My customer buys his servers each time in a set of 12 (one rack). All servers are equipped with a dual-port fiberchannel Host Bus Adapter (HBA). Each port is connected to a different fabric (TOP & BOT fabric).
One of the racks freshly installed a few weeks before the maintenance weekend when we performed a storage-, SAN switch & server upgrade was causing a whole bunch of issues. The fact is that all switches are in a healthy state, no errors are visible in the errorlog and all ports have succesfully performed a Fabric Login Process (FLOGI).
Our customers uses HP Proliant DLxxx G7 servers with a combination of QLogic and Emulex fiberchannel cards. The fiberchannel switches are HP-branded: HP Brocade 8/40 SAN switch.
In a first case, we verified the port configuration:
- Fix speed? Yes, 8G.
- Fillword? Configured with mode 3 (aa-then-ia: attempts hardware arbff-arbff (mode 1) first. If the attempt fails to go into active state, this command executes software idle-arb (mode 2). Mode 3 is the preferable to modes 1 and 2 as it captures more cases.)
and ofcourse the port statistics (and in more detail, the port errors). Here I came to the conclusion the numbers where very static. Wich means the port is online in the fabric, and as no errors are filling up I came to the conclusion the port was not being used in the fabric even it was zoned out with a storage array and a disk has been presented.
When configuring a brand new Brocade San switch settings are configured with factory defaults.
Logging in on the switch can be done by opening an SSH/Telnet session to the SAN switch on IP 10.77.77.77.
Hope this helps.
In some situations, it can come in handy to know the type of switch. However executing a
switchshow command does not give you the information you need. In fact, it does only provide you with the switch type number. By using the table below, you should be able to link the switch type to the Brocade and HP Product Name.
CoreSwitch01a:rendersr> switchshow | more